Ethernet Communication

Setting up the eBase

1.Plug the power cord into the power adapter.

2.Plug the power connector cable into the power connector on the back of the eBase.

3.Plug the A/C power cord into a standard wall outlet. The COMM LED flashes red.

Note: When searching for a network, the 9700 terminal looks for a USB connection first, and then an Ethernet connection. If you only require an Ethernet connection, Honeywell recommends disconnecting the USB cable from the eBase. Remove the Dolphin terminal from the eBase before connecting or disconnecting the USB cable.

4.Plug the CAT-5 Ethernet cable into the RJ45 connector on the back of the eBase.

5.Plug the Ethernet cable into the network.

6.The COMM LED flashes orange while the eBase attempts to acuire an IP address. The COMM LED will change to a solid orange when a network connection has been established.

Connecting the Dolphin Terminal to the eBase

After the eBase is installed, configured, and connected to the host computer, you must connect the Dolphin terminal to the eBase.

1.Remove the Dolphin terminal from the eBase if it is docked.2.On the Dolphin terminal, tap Start > ActiveSync >Menu > Connections

11