Horizon Fitness RE7.6 manual Remove PRE-ATTACHED Bolt & Washers from Console Mast

INTRODUCTION IMPORTANT PRECAUTIONS

ASSEMBLY

BEFORE YOU BEGIN

ELLIPTICAL OPERATION

CONDITIONING TROUBLESHOOTING GUIDELINES & MAINTENANCE

A S S E M B LY STEP 3
		UPPER HANDLEBAR
	NOTCH
CONSOLE MAST		PRE-ATTACHED
		SET SCREWS
	TAB
USE LEFT HANDLEBARS		USE RIGHT HANDLEBARS
		PRE-ATTACHED
		BOLT & WASHER
		LOWER HANDLEBAR

NOTE: There is NO hardware bag for this step. All hardware is pre-installed.

A)Remove PRE-ATTACHED BOLT & WASHERS from CONSOLE MAST.

B)Slide LOWER HANDLEBARS onto CONSOLE MAST and attach by re-inserting PRE-ATTACHED BOLT & WASHERS.

C)Slide UPPER HANDLEBARS onto LOWER HANDLEBARS and align NOTCH with TAB making sure handlebars are joined together completely. Secure UPPER HANDLEBARS to LOWER HANDLEBARS using PRE-ATTACHED SET SCREWS.

Reminder: The upper and lower handlebars are marked with an L if they are to be used on the left-hand side of the elliptical or an R if they are to be used on the right-hand side of the elliptical. If the handlebars are assembled on the incorrect side of the elliptical, the unit will not function correctly.

	After handlebars are assembled they will rotate freely – be cautious. Until the
WARNING
	machine is fully assembled, do not grab the handlebars for support.

LIMITED WARRANTY

10