SELECTING C U S T O M PROGRAM
1)Select CUSTOM PROGRAM (P8) using the PROGRAM keys and press ENTER.
2)Set TIME using the +/- KEYS and press ENTER.
• IF THE PROGRAM IS PREVIOUSLY STORED – After you set the time and press START the previously stored program will begin.
3)Set the RESISTANCE PROFILES using the +/- KEYS and press ENTER after each RESISTANCE PROFILE is set to the desired level (repeat until all 15 segments are chosen).
*Note: If START is pressed it will take you back to previous segment.
4)After the 15th segment is set, press ENTER to save the program then press start to begin the program.
*NOTE: To reset the memory press and hold the ENTER button for 5 seconds.
IMPORTANT PRECAUTIONS INTRODUCTION
ASSEMBLY
BEFORE YOU BEGIN
ELLIPTICAL OPERATION
TROUBLESHOOTING CONDITIONING & MAINTENANCE GUIDELINES
21
LIMITED WARRANTY
