INTRODUCTION IMPORTANT PRECAUTIONS

PRE - ASSEMBLY

DO NOT CUT STRAPS UNTIL STEP 1.4!* Disassemble box and remove the WARNING cardboard packaging that is not beneath the treadmill. Do not attempt to lift the treadmill at this time. Reach under treadmill running deck to locate parts box.

Remove plastic wrap from console masts.

NOTE: It is recommended that you apply grease to the threads of each bolt as you assemble your treadmill, to prevent loosening and noise. Also, during each assembly step, ensure that ALL nuts and bolts are in place and partially threaded in before completely tightening any ONE bolt.

ASSEMBLY

BEFORE YOU BEGIN

TREADMILL OPERATION

A S S E M B LY STEP 1

LEFT CONSOLE MAST

BOLT A

LEFT SIDE LINKAGE ARM

*NOTE: If the straps have been removed before completing STEP 1, refer to the TROUBLESHOOTING section (page 26) in order to restore the treadmill to its proper position.

ALift LEFT CONSOLE MAST into upright position. Be sure to hold the console mast firmly, as it will not stay in the upright position on it’s own.

BMove LEFT SIDE LINKAGE ARM into position. Insert TEFLON WASHER (B) (2 pcs) and BOLT

(A) and tighten.

CRepeat on the right side.

DNow cut the banding straps and remove remaining packaging material.*

CONDITIONING TROUBLESHOOTING LIMITED

GUIDELINES & MAINTENANCE WARRANTY

7

A S S E M B LY STEP 2

A Lift the RUNNING DECK until lock latch is fully engaged.

1

B Remove CONSOLE from box

 

 

and place out of the way.

3

C Lower the treadmill RUNNING DECK from the folded position

2 by stepping on LOCK LATCH on lower right side.

Page 8
Image 8
Horizon Fitness T62, T61, T64, T63 manual Tighten Repeat on the right side, By stepping on Lock Latch on lower right side