Hoshizaki KM-61BAH, KM-101BAH, KM-151BWH, KM-151BAH Fig, Drain lines should not be piped directly

Models: KM-151BAH KM-151BWH KM-61BAH KM-101BAH

1 22

Page 13

* Drain lines should not be piped directly	KM-61BAH, KM-101BAH, KM-151BAH
to the sewer system. An air gap of a
minimum of 2 vertical inches (5 cm)
should be between the end of the drain
pipes from the icemaker and the floor
drain.
* This icemaker should be installed in
accordance with applicable national,
state and local regulations.
* A plumbing permit and services of a
licensed plumber may be required in
some areas.

Drain Outlet 3/4” FPT

Water Supply Inlet 1/2” FPT

Fig. 4

Image 13

Contents

SELF-CONTAINEDCRESCENT CUBER INSTRUCTION MANUALKM-61BAH KM-101BAH KM-151BAH KM-151BWH L1M006102HOSHIZAKI AMERICA, INC 618 Highway 74 South Complete and detailed explanation of the problemPeachtree City, GA Attn: Hoshizaki Technical Support DepartmentPAGE CONTENTSI. Speciﬁcations A. Nameplate Rating 1. KM-61BAH B. Dimensions/ConnectionsUnit: mm inches 2. KM-101BAHUnit: mm inches 3. KM-151BAHUnit: mm inches 4. KM-151BWHB. How to Remove Panels - See Fig. Fig. C. Location D. Electrical Connection E. Set UpTHIS APPLIANCE MUST BE GROUNDED F. Water Supply and Drain Connections - See Fig. Fig.Fig. Drain lines should not be piped directly Fig.Bin Drain Outlet Fig.Condenser Water 3/4” FPTG. Final Checklist Fig. H. StartupA. Cleaning III. Cleaning and Maintenance Instructions1.Cleaning Procedure 7Same as step Fig.Fig. 16Wash the Bin Control Switch, Water Tank, Float Switch, Cube Guide, Silicone Hose and Overﬂow Pipe by using a nylon scouring pad, brushes and the cleaning solution. In addition to the removed parts, also wash the bin liner and Bracket L R with the solution1. Exterior Panels B. Maintenance2. Storage Bin and Scoop 3. Air Filter C. Preparing the Icemaker for Long Storage4. Condenser 2.Drain the potable Water Tank