III. OPERATING INSTRUCTIONS
1. FUNCTIONS AND ADJUSTMENT OF SET ITEMS
The water electrolyzer is provided with the nine set items of the following functions:
No. | Set Items |
|
| Functions | ||
|
|
| ||||
A1 | Cell Lifecycle (h) | Adjustment is required if the electrode lifecycle gets longer | ||||
|
| 3000 - 8000 | (Initial: 3000 h). | |||
|
|
| ||||
A2 | Amperage (A) | Changes the pH value (Initial: 14.0 A). | ||||
|
| 0.0 - 18.0 | To increase the pH value, raise the amperage. | |||
|
|
| ||||
A3 | Voltage (V) | Changes the available chlorine concentration (Initial: 10.0 V). | ||||
|
| 0.0 - 18.0 | To reduce the residual chlorine concentration, raise the voltage. | |||
|
|
| ||||
A4 | Cell Reverse Time (h) | Adjustment is required if the electrode lifecycle gets longer | ||||
|
| 0 - 150 | (Initial: 12 h, 0 means no reversal). | |||
|
|
| ||||
A5 | Amperage | Changes the reaction to the varying amount of additional | ||||
|
| Accumulation Time (s) | concentrated salt water (Initial: 3 s). To delay the amperage | |||
|
| 1 - 90 | feedback reaction, extend the time setting. | |||
|
|
| ||||
A6 | Storage Mode/ | Chooses between | ||||
|
| remote controller and storage mode to store water in the tank | ||||
|
|
| (Initial: | |||
|
|
| ||||
A7 | Cell Running/ | Resets the | ||||
|
| Reverse Time Reset |
|
|
|
|
|
|
| ||||
A8 | Initial Flush Cycle (s) | Changes the time to supply water for flushing away non- | ||||
|
| 0 - 120 | electrolyzed water in the Electrolytic Cell in the initial operation | |||
|
|
| (Initial: 3 s). | |||
|
|
| ||||
A9 | Automatic Dispensing | Adjusts the dispensing time for automatic dispensing control | ||||
|
| Control 10 s - 4 m | (Initial: continuous). | |||
|
|
| Continuous: Continuously dispenses until the Dispensing | |||
|
|
|
| Button is pushed for the second time. | ||
|
|
| Automatic: Automatically stops when the adjusted time has | |||
|
|
|
| passed since the Dispensing Button is pushed. | ||
|
|
|
|
|
|
|
|
|
|
| IMPORTANT |
|
|
|
|
|
|
| ||
1.The set items A1, A4, A5, A8 and A9 should not be changed unless directed by an engineer.
2.The set item A7 should be used only when the Electrolytic Cell is replaced.
Note: 1. The set amperage and voltage can be changed just by turning each control volume. For more accurate adjustment, however, always use the A2 and A3 adjust modes
U8AA5540012 | 13 |
