SURFACE COOKING
Lighting Instructions for Standing Pilot Models
NOTE: Make sure all the grates on the range are in place before using any burner.
The surface burners on these models have standing pilots that must be lit initially. To light them:
1.Be sure surface burner control knobs are in the OFF position.
2.Remove the grates and lift the cooktop up (see the Care and Cleaning section).
3.Locate the two pilot
ports and light each of them with a match.
NOTE: If the pilot is too high or low, you can adjust it. See the Installation Instructions.
4.Lower the cooktop. Your surface burners are now ready for use.
5.Observe lighted burners. Compare the flames to pictures in the Installation Instructions. If any flame is unsatisfactory, call for service.
Lighting Instructions for Electric Ignition Models
NOTE: Make sure all the grates on the range are in place before using any burner.
The surface burners on these models are lighted by electric ignition, eliminating the need for standing pilot lights with constantly burning flames.
In case of a power failure, you can light the surface burners on your range with a match. Hold a lighted match to the burner, then turn the knob to the LITE position. Use extreme caution when lighting burners this way.
Surface burners in use when an electrical power failure occurs will continue to operate normally.
Surface Burner Controls
Knobs that turn the surface burners on and off are marked as to which burners they control. The two knobs on the left control the left front and left rear burners. The two knobs on the right control the right front and right rear burners.
10
