Nonsystem disk/NTLDR missing message.

Cause

Solution

 

 

The system is trying to start from the hard drive but the hard

1. Perform Drive Protection System (DPS) testing in

drive may have been damaged.

 

system ROM.

 

 

System files missing or not properly installed.

1. Insert bootable media and restart the computer.

 

2.

Boot to the windows installation media and select the

 

 

recovery option. If only a restore kit is available, then

 

 

select the File Backup Program option, and then

 

 

restore the system.

 

3.

Install system files for the appropriate operating system.

 

 

Hard drive boot has been disabled in Computer Setup.

Run the Computer Setup utility and enable the hard drive

 

entry in the Storage > Boot Order list.

 

 

Bootable hard drive is not attached as first in a multi-hard

If attempting to boot from a hard drive, ensure it is attached

drive configuration.

to the system board dark blue SATA connector.

 

 

Bootable hard drive is not listed first in the Boot Order.

Run the Computer Setup utility and select Storage > Boot

 

Order and ensure the bootable hard drive is listed

 

immediately under the Hard Drive entry.

 

 

 

Computer will not boot from hard drive.

 

 

 

 

Cause

Solution

 

 

The device is attached to a SATA port that has been hidden

1. Check SATA cable connections.

in Computer Setup.

2.

Run the Computer Setup utility and ensure Device

 

 

 

Available is selected for the device's SATA port in

 

 

Security > Device Security.

 

 

Boot order is not correct.

Run the Computer Setup utility and change boot sequence in

 

Storage > Boot Order.

 

 

Hard Drive's “Emulation Type” is set to “None.” (some

Run the Computer Setup utility and change the “Emulation

models)

Type” to “Hard Disk” in the device's details under Storage >

 

Device Configuration.

 

 

Hard drive is damaged.

Observe if the front panel Power LED is blinking RED and if

 

any beeps are heard. See Appendix A, POST Error

 

Messages on page 127 to determine possible causes for the

 

blinking red and beep codes.

See the Worldwide Limited Warranty for terms and conditions.

90 Appendix A Troubleshooting Without Diagnostics

Page 97
Image 97
HP 1105 manual Nonsystem disk/NTLDR missing message Cause Solution, Computer will not boot from hard drive Cause Solution