Power connector cable
Description | Spare part number |
|
|
Power connector cable | |
|
|
Before removing the power connector cable, follow these steps:
1.Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on, and then shut it down through the operating system.
2.Disconnect the power from the computer by unplugging the power cord from the computer.
3.Disconnect all external devices from the computer.
4.Remove the battery (see Battery on page 46), and then remove the following components:
a.Optical drive (see Optical drive on page 47)
b.Hard drive (see Hard drive on page 49)
c.WLAN module (see WLAN module on page 51)
d.Keyboard (see Keyboard on page 56)
e.Top cover (see Top cover on page 60)
f.
Remove the power connector cable:
1.Disconnect the power connector cable (1) from the system board.
2.Release the power connector cable from the clips (2) built into the base enclosure.
92 | Chapter 6 Removal and replacement procedures for Authorized Service Provider parts |
