Optical drive
NOTE: This section applies only to computer models equipped with an Intel processor.
Description | Spare part number |
|
|
|
|
Before removing the optical drive, follow these steps:
1.Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on, and then shut it down through the operating system.
2.Disconnect the power from the computer by unplugging the power cord from the computer.
3.Disconnect all external devices from the computer.
4.Remove the battery (see Battery on page 46).
Remove the optical drive:
1.Loosen the Phillips PM3.0×10.0 captive screw (1) that secures the service cover to the computer.
2.Slide the service cover (2) forward until it disengages from the computer.
3.Remove the service cover (3).
The service cover is available using spare part number
4.Position the computer with the left side toward you.
5.Remove the Phillips PM2.5×3.5 screw (1) that secures the optical drive to the computer.
6.Insert a
Component replacement procedures | 47 |
