Quantity Setup
Sets the method to specify the number of copies to print. Candidate values are shown below.
[Protocol] (default) [Stored Jobs] [Command]
2 Sided Print
Sets 2 sided printing. [Off]
2 sided printing is not done. [Long Edge Flip]
Printing is done from left to right. [Short Edge Flip]
Printing is done from top to bottom.
Note
• Can be set when the duplex unit (optional) is installed.
Output Tray
Specifies the tray to which the printed paper is ejected. [Center Tray] (default)
[Rear Tray] [OffsetCatchTray]
Note
•You can set [Rear Tray] when the optional rear tray is installed.
•You can set [OffsetCatchTray] if the optional offset catch tray is installed.
Adjust Position
Moves the hard clip area vertically or horizontally. This setting can be made in 1 mm increments within the range between
[Up & Down]
You can set this item in 1 mm increments from
The default value is [0 mm].
[Left & Right]
You can set this item in 1 mm increments from
The default value is [0 mm].
Note
•Data outside the print area will not be printed even if the position is adjusted.
•Data that has gone out of the print area as the result of positional adjustment will not be printed.
•When changing the candidate values by the <
> or <
> button, you can change the display continuously by holding the button down. Also, pressing the <
> and <
> buttons simultaneously displays the default value.
2.2 | 17 |