Determining the Scaling Factor

During execution of auto scaling, the scaling factor is determined by the document size and output size. Note that the scaling factor depends on the [Zoom Mode] setting.

Note

•To enable the scaling function, set [Zoom] to [On] on the control panel. If [Zoom] is set at [Off], images will be drawn at a scale of 100%.

When [Document Size] Is Set to [Auto] and [Zoom Mode] Is Set to [Output Size]

The [Hard Clip] setting becomes ineffective. The output size hard clip area is always used.

•When the document size is the same as the output size, the image is drawn at a scale of 100%.

•When the document size is larger than the output size, the image is drawn with it reduced.

•When the document size is smaller than the output size, the image is drawn at a scale of 100%.

Output size

A3

A4

A5

B4

B5

Document

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

A0

35

25

100

31

100

 

 

 

 

 

 

A1

50

35

25

43

31

 

 

 

 

 

 

A2

71

50

35

61

43

 

 

 

 

 

 

A3

100

71

50

87

61

 

 

 

 

 

 

A4

100

100

71

100

87

 

 

 

 

 

 

A5

100

141

100

173

100

 

 

 

 

 

 

Note

•When origin position is set to layout, the image is drawn with the document laid out at the center. When origin position is set to bottom left or center, the image is drawn with the origins of the document and paper aligned.

•Some output sizes may not be used depending on the printer type.

3.3 Auto Layout

33