Time Protocols

TimeP: Viewing, Selecting, and Configuring

The commands and output would appear as follows:

1show timep displays the TimeP configuration and also shows that SNTP is the currently active time synchronization mode.

2

3

4

show timep again displays the TimeP configuration and shows that TimeP is now the currently active time synchronization mode.

Figure 9-12. Example of Enabling TimeP Operation in DHCP Mode

Enabling Timep in Manual Mode. Like DHCP mode, configuring TimeP for Manual mode enables TimeP. However, for manual operation, you must also specify the IP address of the TimeP server. (The switch allows only one TimeP server.) To enable the TimeP protocol:

Syntax: timesync timep

Selects Timep.

ip timep manual <ip-addr>

Activates TimeP in Manual mode with a specified TimeP server.

no ip timep

Disables TimeP.

Note

To change from one TimeP server to another, you must (1) use the no ip timep command to disable TimeP mode, and then reconfigure TimeP in Manual mode with the new server IP address.

For example, to select TimeP and configure it for manual operation using a TimeP server address of 10.28.227.141 and the default poll interval (720 minutes, assuming the TimeP poll interval is already set to the default):

9-19