Multicast Listener Discovery (MLD) Snooping
Displaying MLD Status and Configuration
The specific form of the command might look like this:
ProCurve# show ipv6 mld vlan 8 config
MLD Service Vlan Config
VLAN | ID : 8 |
|
|
|
|
|
VLAN | NAME : VLAN8 | : Yes |
|
|
| |
MLD Enabled [No] | : Yes |
|
| |||
Querier Allowed [Yes] |
|
| ||||
Port | Type | Port | Mode | Forced Fast Leave Fast Leave | ||
A13 | 100/1000T | auto |
| No | Yes | |
A14 | 100/1000T | auto |
| No | Yes | |
A15 | 100/1000T | auto |
| No | Yes | |
A16 | 100/1000T | auto |
| No | Yes | |
A17 | 100/1000T | auto |
| No | Yes | |
A18 | 100/1000T | auto |
| No | Yes | |
A19 | 100/1000T | auto |
| No | Yes | |
A20 | 100/1000T | auto |
| No | Yes | |
A21 | 100/1000T | auto |
| No | Yes | |
A22 | 100/1000T | auto |
| No | Yes | |
A23 | 100/1000T | auto |
| No | Yes | |
A24 | 100/1000T | auto |
| No | Yes |
The following information is shown, if the specified VLAN is
■VLAN ID and name
■whether MLD is enabled on the VLAN (default NO, but the information for this VLAN will be listed only if MLD is enabled)
■whether the switch is allowed to act as querier on the VLAN