IPv6 Addressing Configuration
Enabling DHCPv6
Enabling DHCPv6Enabling the DHCPv6 option on a VLAN allows the switch to obtain a global unicast address and an NTP (network time protocol) server assignment for a Timep server. (If a DHCPv6 server is not needed to provide a global unicast address to a switch interface, the server can still be configured to provide the NTP server assignment. This is sometimes referred to as “stateless DHCPv6”.)
Syntax: [no] ipv6 address dhcp full
This option configures DHCPv6 on a VLAN, which initiates transmission of DHCPv6 requests for service. If IPv6 is not already enabled on the VLAN by the ipv6 enable command, this option also enables IPv6 and causes the switch to autocon figure a
Notes: A DHCPv6 server does not assign
A
•The assigned address is not on the same subnet as a previously configured autoconfig address.
•The maximum IPv6 address limit on the VLAN or the switch has not been reached.
If a DHCPv6 server responds with an IPv6 address assign ment, this address is assigned to the VLAN. (The DHCPv6- assigned address will be dropped if it has the same subnet as another address already assigned to the VLAN by an earlier autoconfig command.)
— Continued on the next page. —