IPv6 Management Features
Telnet6 Operation
Enabling or Disabling Inbound Telnet6 Access
Syntax: [ no ]
This command is used at the global config level to enable (the default) or disable inbound Telnet6 access to the switch.
The no form of the command disables inbound telnet6.
Note: To disable inbound Telnet access completely, you must disable Telnet access for both IPv6 and IPv4. (The command for disabling Telnet4 access is no
For example, to disable Telnet6 access to the switch, you would use this com mand:
ProCurve(config)# no
Viewing the Current Inbound Telnet6 Configuration
Syntax: show console
This command shows the current configuration of IPv4 and IPv6 inbound telnet permissions, as well as other informa tion. For both protocols, the default setting allows inbound sessions.
Telnet6 Setting
Console/Serial Link
Inbound Telnet Enabled [Yes] : Yes
Inbound Telnet6 Enabled [Yes] : Yes
Web Agent Enabled [Yes] : Yes
Terminal Type [VT100] : VT100
Screen Refresh Interval (sec) [3] : 3
Displayed Events [All] : All
Baud Rate [Speed Sense] :
Flow Control [XON/XOFF] : XON/XOFF
Session Inactivity Time (min) [0] : 0
Figure