IPv6 Addressing Configuration
View the Current IPv6 Addressing Configuration
ProCurve(config)# | show ipv6 |
| ||
Internet (IPv6) Service |
| |||
IPv6 Routing |
| : Disabled |
| |
Default Gateway | : 10.0.9.80 |
| ||
ND DAD |
|
| : Enabled |
|
DAD Attempts |
| : 3 |
| |
Vlan Name |
|
| : DEFAULT_VLAN |
|
IPv6 Status |
|
| : Disabled |
|
Vlan Name |
|
| : VLAN10 |
|
IPv6 Status |
|
| : Enabled |
|
Address | IPv6 Address/Prefix Length | Address | ||
Origin | Status | |||
+ | ||||
preferred | ||||
dhcp | 2620:0:a03:e102:212:79ff:fe88:a100/64 | preferred | ||
manual | fe80::127/64 | preferred |
Syntax: show ipv6 vlan < vid >
Displays IP and IPv6 global configuration settings, the IPv6 status for the specified VLAN, the IPv6 addresses (with prefix lengths) configured on the specified VLAN, and the expiration data (Expiry) for each address.:
■IPv6 Routing: For software release K.13.01, this setting is always Disabled. (Refer to “Router Access and Default Router Selection” on page
■Default Gateway: Lists the IPv4 default gateway, if any, configured on the switch. This is a globally configured router gateway address, and is not configured
■ND DAD: Shows whether Neighbor Discovery (ND) is enabled. The default setting is Enabled. Using ipv6 nd dad- attempts 0 disables neighbor discovery.