IPv6 Management Features
SNTP and Timep
| For example, to configure |
| of: |
| ■ fe80::215:60ff:fe7a:adc0 (on VLAN 10, configured on the switch) |
| ■ 2001:db8::215:60ff:fe79:8980 |
| as the priority “1” and “2” SNTP servers, respectively, using version 7, you |
| would enter these commands at the global config level, as shown below. |
| ProCurve(config)# sntp server priority 1 |
| fe80::215:60ff:fe7a:adc0%vlan10 7 |
| ProCurve(config)# sntp server priority 2 |
| 2001:db8::215:60ff:fe79:8980 7 |
|
|
N o t e | In the preceding example, using a |
| the local scope for the address; VLAN 10 in this case. This is always indicated |
| by %vlan followed immediately (without spaces) by the VLAN identifier. |
| Syntax:. show sntp |
| |
| Displays the current SNTP configuration, including the |
| following: |
| Time Sync Mode: Indicates whether timesync is disabled or set |
| to either SNTP or Timep. (Default: timep) |
| SNTP Mode: Indicates whether SNTP uses the broadcast or |
| unicast method of contacting a time server. The broadcast |
| option does not require you to configure a time server address. |
| The unicast option does require configuration of a time server |
| address. |
| Poll Interval: Indicates the interval between consecutive time |
| requests to an SNTP server. |
| Priority: Indicates the configured priority for the corresponding |
| SNTP server address. |
| SNTP Server Address: Lists the currently configured SNTP |
| server addresses. |
| Protocol Version: Lists the SNTP server protocol version to |
| expect from the server at the corresponding address. |