use printing features

clean the printheads

Use this feature when the self-test report, which is generated from the front-panel, shows streaking or white lines through any of the colored bars. Do not clean printheads unnecessarily; this wastes ink and shortens the life of your printheads.

Tip: Although this feature is available in the Device Services tab, we recommend that you use the front-panel instead.

1In the Device Services tab, click Clean the Printheads.

2On the next screen, click Clean.

A test page will print, and a dialog box will appear with the options Intermediate Clean or Done.

–If the print quality on the test page is poor, click Intermediate Clean.

–If the print quality on the test page is good, click Done.

If you select Intermediate Clean, a new test page will print and a new screen will appear with the options, Prime or Done.

–If the print quality is poor, click Prime.

–If the print quality on the test page is good, click Done.

If you select Prime, a new test page will print and a new screen will appear with the options Clean Again or Done. Select Clean Again if further cleaning is needed, or click Done.

3When you are finished, click Close.

print a test page

This tool allows you to confirm that the connection between your HP Digital Copier Printer and your computer is working properly. This test page is different than the self-test report that you can print from the front-panel.

`In the Device Services tab, click Print a Test Page.

The test page prints as long as your connection is working properly.

use the configuration tab

The Configuration tab allows you to specify the way your HP Digital Copier Printer is set up. It also allows you to configure the copier/printer to conserve energy by automatically running in power-saving mode after it has not been used for a certain amount of time.

Note: The following options are permanently disabled, because they are not available with the HP Digital Copier Printer 410:

–Display Print Settings Confirmation Dialog

–Display Status Window

–Configure Status Messages

–Attempt to Use Hardware ECP

access the configuration tab

1Right-click the printer icon in the system tray, make sure hp digital copier 410 is marked with a checkmark, and then select Open the hp digital copier 410 Toolbox.

The HP Digital Copier 410 Toolbox appears. It contains two tabs. By default, the Toolbox opens to the Device Services tab.

2Click the Configuration tab.

printing guide

27