
Removal and replacement procedures
3.Turn the computer
4.Disconnect the power connector cables 1 from the system board.
5.Release the power connector cables from the clips 2 and routing channel built into the top cover.
6.Disconnect the network cable 3 from the system board.
7.Release the network cable from the clips 4 and routing channel built into the top cover.
8.Remove the five slotted Torx T8M2.5×7.0 screws 1 and the Torx T8M2.5×6.0 screw 2 that secure the top cover to the base enclosure.
Maintenance and Service Guide |