HP 600B MT Computer Setup—Power, Computer Setup

Computer Setup—Power

NOTE: Support for specific Computer Setup options may vary depending on the hardware

configuration.

Table 2-5Computer Setup—Power

Option	Description

Hardware Power	SATA Power Management – Enables or disables SATA bus and/or device power management.
Management	Default is enabled.
	S5 Maximum Power Savings—Turns off power to all nonessential hardware when system is off to
	meet EUP Lot 6 requirement of less than 1 Watt power usage. Default is disabled.

Thermal	Fan idle mode—This bar graph controls the minimum permitted fan speed.
Thermal
	NOTE: This setting only changes the minimum fan speed. The fans are still automatically
	controlled.

Computer Setup—Advanced

NOTE: Support for specific Computer Setup options may vary depending on the hardware

configuration.

Table 2-6Computer Setup—Advanced (for advanced users)

Option	Heading

Power-On Options	Allows you to set:
	● POST messages (enable/disable). Default is disabled.
	● After Power Loss (off/on/previous state). Default is Power off. Setting this option to:
	◦ Power off—causes the computer to remain powered off when power is restored.
	◦ Power on—causes the computer to power on automatically as soon as power is restored.
	◦ Previous state—causes the computer to power on automatically as soon as power is
	restored, if it was on when power was lost.
	NOTE: If you turn off power to the computer using the switch on a power strip, you will not be
	able to use the suspend/sleep feature or the Remote Management features.
	● POST Delay (in seconds). Enabling this feature will add a user-specified delay to the POST
	process. This delay is sometimes needed for hard disks on some PCI cards that spin up very
	slowly, so slowly that they are not ready to boot by the time POST is finished. The POST delay
	also gives you more time to select F10 to enter Computer (F10) Setup. Default is None.

BIOS Power-On	Allows you to set the computer to turn on automatically at a time you specify.