HP 9000 manual Installation

INSTALLATION

Blocking (De-blocking) the Guiding Bar in horizontal position

The stand has a provision for blocking the guiding bar so that the output stacker, after being pulled back from the printer for jam removal, can be pushed back easily and without risk to tip over.

∙ To activate the blocking mechanism, push the bolt into the guiding bar and fix it in position with the knurled screw (Fig. 18).

Fig. 18

Attaching the Output Stacker to the Printer

∙Insert the guiding bar of the stand into the guide holder that is on the rear lower side of TowerFeed (Fig. 19).

Fig. 19

∙Slide-in the blue plastics guide until it snaps into position (Fig. 20).

Fig. 20

∙ Push the stand with the output stacker towards the printer system until the stacker's spring-loaded hooks snap into the printer's cutouts.

Fig. 21

∙Adjust the output stacker inclination using the two blue adjustment wheels of the outside stacker rollers (Fig. 21, Fig. 22a+b) until the output stacker is parallel to the printer (Fig. 22c)

∙Adjust clamp and tighten its screw (Fig. 22d)

			d
		Fig. 22
IU 675 / 0150	9	TowerFeedTM for the HP LaserJet 9000