Working with the Locations Tree and the Devices List
Figure 15. Copying a location
2Right‐click the destination location folder onto which you want to paste the location selected in the above step. Select Paste.
If the location where you are pasting the location folder or node already has a folder or node with the same name, Planner renames the copied objects incrementally with a suffix ‘01’, ‘02’, and so on.
Note: If a node belongs to a Cross Floor location folder, you cannot Cut/Copy and Paste that node into another folder. If you want to copy that node, you must copy the entire Cross Floor location folder.
4.1.8Moving a Location
You can move location folders and nodes within a location folder. This changes the location hierarchy of that folder in the project.
Note: You cannot move a location if the location is not under the same parent location folder.
Use the following steps to move a location:
1Right‐click a location folder or node from the Locations tree.
2Select Move Up or Move Down.3Repeat the above steps until you reach the destination folder under which you want to move the selected location.
Figure 16. Moving a location
4.1.9Placing Locations on a Location Folder with an attached image
Planner enables you to place locations on a location folder that has an attached image. This helps you identify the physical position of each of the locations. The locations placed on the attached image are indicated by green colored circles. Use the following steps to place locations on the attached image and view their details:
1In the Locations tree, select a location folder.
2The bottom left pane called Locations shows all the nodes and folders available under the selected location folder. Drag and drop the required locations on the attached image, in the right pane.
3To view details about the location, hold the mouse cursor over the green colored bullets.
18
3Com ® AirProtect Planner User Guide