Display
(HP Authorized Service Providers Only)The below table summarizes the compatibility of displays between the OmniBook 2000, 5500, and 5700. Please note, that the proper Icon Board must be matched with the corresponding display type and manufacturer.
Table 18 - Display Compatibility Matrix| Display Part # | Display Type | OB2000 | OB5500 | OB5700 | Icon Board1 | Part Number |
| 10.4” TFT |
| ü |
| PCA | ||
| 11.3” DSTN |
| ü |
| PCA | ||
| 12.1” TFT Hitachi* | ü | ü | ü | PCA | ||
|
|
|
|
| PCA | |
| 12.1” TFT Samsung* | ü | ü | ü | PCA | ||
|
|
|
|
| PCA | |
| 12.1” TFT XGA |
|
| ü | PCA | ||
| 12.1” DSTN | ü |
|
| PCA |
*At the time of this printing, Samsung is considered the primary supplier of 12.1” TFT displays. Unless otherwise indicated, all 12.1” TFT SVGA orders should be placed against
Required Equipment
∙Small phillips screwdriver
Removal Procedure
1.Exit all applications, including Windows.
2.Turn the OmniBook off and remove the battery and ac adapter.
3.Follow the Hard Disk Drive Removal Procedure on page 67.4.Turn the unit over and remove the two display screws located under the plastic feet. See Figure 25 on page 72.
5.Turn the unit back over and remove the Icon Assembly by applying pressure with the thumbs. See Figure 26 on page 72. Note, it is helpful to lift up on the display slightly.
6.The Icon Assembly flex cable may be disconnected at this point to completely remove the Icon Assembly, however, it is not necessary for the removal of the display.
7.With the Icon Assembly either removed or out of the way, disconnect the Display Cables4 and the two Display Grounding Cables. See Figure 27 on page 73.
1Refer to Table 20 - Icon Board Compatibility Matrix on page 79.
2For the OmniBook 5500 only
3For the OmniBook 2000 and 5700 only
4The type of display cables (such as flex or wire harness) may vary depending on the type of display (such as TFT or DSTN).
71