Vpp2 tolerance error (12V) = N.NN) Card Vpp2 12V = N.NN (XX)

Vpp2 tolerance error (3.3V) = N.NN) Vpp2 tolerance error (3.3V) = N.NN) Vpp2 tolerance error (5V) = N.NN)

Vpp1 tolerance error (12V) = N.NN) -REG bit error - stuck high

-REG bit error - stuck low

Address miscompare, access = XXXXXXXX, latched = XXXXXXXX Address miscompare, access = XXXXXXXX, latched = XXXXXXXX Error - Wait bit has no effect

BVD1/-STSCNG (Pin 63) error - stuck low BVD1/-STSCNG (Pin 63) error - stuck high BVD2/-SPKR (Pin 62) error - stuck low BVD2/-SPKR (Pin 62) error - stuck high WP/-IOIS16 (Pin 33) error - stuck low READY/-IREQ (Pin 16) error - stuck low Reset error - stuck low

Reset error - stuck high

Card Detect Error -CD1 stuck high Card Detect Error -CD1 stuck low

Disk Drives (SCSI HD / internal HD / Floppy)

Internal Diag error: not enough memory for disk buffer.

Failed: no scsi or dock connection.

Error X resetting drive.

Error reading drive parameters.

Failed: no formatted Floppy in drive.

Failed: disk is write protected.

Error: data read does not match data written.

(Note: when the above error occurs, the status window will report the offset where the mismatch occurred and four bytes of expected and actual

data as follows: Data ERROR offset NNN wrote:XX-XX-XX-XX read:XX-XX-XX-XX)

Error X at track T, head H, sector S.

1.4Mb/813Mb/1.4Gb Ok SeekRetries=N, ReadRetries=N, WriteRetriees=N

The codes reported translate to the following errors:

0x00 successful completion

0x01 invalid function in AH or invalid parameter

0x02 address mark not found

0x03 disk write-protected

0x04 sector not found/read error

0x05 reset failed (hard disk)

0x06 disk changed (floppy)

0x07 drive parameter activity failed (hard disk)

0x08 DMA overrun

0x09 data boundary error attempted DMA across 64K boundary or >80h sectors 0x0A bad sector detected (hard disk)

0x0B bad track detected (hard disk) 0x0C unsupported track or invalid media

0x0D invalid number of sectors on format (PS/2 hard disk)

88