HP c7000 manual Removal and replacement procedures

oFull-height blades: bays 1-5 ("Half-height or full-height blade" on page 33) o Device bay blanks: bays 9-13 ("Device bay blank" on page 31)

oPower supplies or blanks: bays 1-4 ("HP BladeSystem c7000 power supply or power supply blank" on page 30)

3.Remove the three T-10 Torx screws that secure the Insight Display cable center cover, and then remove the cover.

4.Remove the two T-10 Torx screws that secure the Insight Display cable contour cover, and then remove the cover.

5.Disconnect the Insight Display cable.

6.Remove the two T-10 Torx screws that secure the Insight Display.

7.Remove the upper brace.

8.Tilt the Insight Display forward and remove it from the enclosure.

Removal and replacement procedures 35