HP Cassette Player DDS-3 manual SCSI-2 Connection and Termination, # /etc/shutdown -h Return

Introduction

8/12/5.6.0		disk	MICROP 2112
10	bc		I/O	Adapter
10/12		ext_bus	GSC	add-on Fast/Wide SCSI Interface
10/12.4		target
10/12.4.0		disk	SEAGATE ST31200W

3.Shut down the system.

If you are running HP-UX under HP VUE, shut down your system according to the shutdown procedure described in the owner's guide that came with your worksta- tion.

If you are running HP-UX without HP VUE, shut down your system by typing the following command:

#/etc/shutdown -h RETURN

You must have superuser privileges to use the /etc/shutdown command. If you do not have superuser privileges, contact your system administrator.

If your workstation is part of a cluster, refer to Managing Clusters of HP 9000 Com- puters for instructions on shutting down.

SCSI-2 Connection and Termination

Only single-ended SCSI-2 configuration is supported.

Only unshielded connectors can be used.

The DDS-3 drive does not support termination on the device itself. Normally, drives such as this are not required to be at the end of a bus, but if this is unavoidable, HP recommends using a feed-through SCSI terminator that plugs directly into the rear of the drive.

1±12