Troubleshooting and Removal/Replacement Procedures
2.Attach the
3.Shut down
NOTICE: If you are already at the boot administration level, you do not need to shut down; skip this step and go on to Step 4.
If you are running
If you are running
#/etc/shutdown -h RETURN
You must have superuser privileges to use the /etc/shutdown command. If you do not have superuser privileges, contact your system administrator.
If your workstation is part of a cluster, refer to Managing Clusters of HP 9000 Com- puters for instructions on shutting down.
4.Power off the workstation, using the power switch on the front of the workstation.
CAUTION: Do not power off your workstation without first shutting down
5.Remove the drive and check the jumpers, as described in ªRemoval/Replacement Proceduresº at the end of this chapter.
6.Replace the drive.
7.Check the cable connections of your
3±4