Power connector
Description | Spare part number |
|
|
Power connector (includes cable) | |
|
|
Before removing the power connector cable:
1.Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn on the computer, and then shut it down through the operating system.
2.Disconnect all external devices connected to the computer.
3.Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then unplugging the AC adapter from the computer.
4.Remove the following components:
a.Battery (see Battery on page 36)
b.Hard drive (see Hard drive on page 37)
c.WLAN module (see WLAN module on page 42)
d.Keyboard (see Keyboard on page 46)
e.Top cover (see Top cover on page 49)
Remove the power connector cable:
1.Position the computer upright, with the right side toward you.
2.Disconnect the power connector cable (1) from the system board.
3.Lift the power connector (2) from the clips built into the base enclosure.
Reverse this procedure to install the power connector.
58 Chapter 4 Removal and replacement procedures
