Switch cover
Description | Spare part number |
|
|
Switch cover for use in dv3000 models (includes LED board and cable) | |
|
|
Switch cover for use in dv3500 models (includes LED board and cable) | |
|
|
Before removing the switch cover, follow these steps:
1.Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on, and then shut it down through the operating system.
2.Disconnect all external devices connected to the computer.
3.Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then unplugging the AC adapter from the computer.
4.Remove the battery (see Battery on page 43).
5.Remove the keyboard (see Keyboard on page 54).
Remove the switch cover:
1.Close the computer.
2.Turn the computer upside down, with the rear panel toward you.
3.Remove the two Phillips PM2.5×7.0 screws (1) and the four black Phillips PM2.0×4.0 screws (2) that secure the switch cover to the computer.
4.Turn the computer
5.Open the computer as far as possible.
6.Release the ZIF connector (1) to which the LED board cable (2) is connected, and disconnect the cable from the system board.
Component replacement procedures 57
