HP DV3000 manual

Before removing the processor, follow these steps:

1.Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on, and then shut it down through the operating system.

2.Disconnect all external devices connected to the computer.

3.Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then unplugging the AC adapter from the computer.

4.Remove the battery (see Battery on page 43).

5.Remove the following components:

a.Optical drive (see Optical drive on page 48)

b.Hard drive (see Hard drive on page 51)

c.Keyboard (see Keyboard on page 54)

d.Switch cover (see Switch cover on page 57)

e.Top cover (see Top cover on page 58)

f.Display assembly (see Display assembly on page 63)

g.System board (see System board on page 70)

h.Heat sink (see Heat sink on page 80)

Remove the processor:

1.Turn the processor locking screw (1) one-half turn counterclockwise until you hear a click.

2.Lift the processor (2) straight up and remove it.

NOTE: When you install the processor, the gold triangle (3) on the processor must be aligned with the triangle icon (4) embossed on the processor slot.

Reverse this procedure to install the processor.

Component replacement procedures 83