Removal and Replacement Procedures
3.Make note of which wireless antenna cable is attached to which antenna clip on the Mini Card module before disconnecting the cables. Then disconnect the cables 1 from the module.
4.Remove the two Phillips PM2.0×11.0 screws 2 that secure the Mini Card module to the computer. (The edge of the module opposite the socket rises away from the computer).
5.Remove the module 3 by pulling it away from the socket at an angle.
✎Mini Card modules are designed with a notch 4 to prevent incorrect installation into the Mini Card module socket.
Removing a Mini Card Module
Reverse the above procedure to install a Mini Card module.
Maintenance and Service Guide |
