Installing the Memory Module

1

This document provides instructions for upgrading the memory module on the library robotics controller. The memory module upgrade process consists of the following steps:

Preparing the Library for the Upgrade

Removing the Robotics Controller

Removing and Replacing the Memory Module

Completing the Procedure

To complete this upgrade you will need:

Memory module

Library firmware (on memory module)

Tools

5/32 inch Allen wrench

#2 Phillips screwdriver

#1 Phillips screwdriver

Electrostatic Discharge (ESD) wrist strap connected by a ground cord to a grounded workstation or chassis

HP StorageWorks ESL9000 Series Tape Library Memory Module Upgrade Guide

11

Page 11
Image 11
HP ESL9000 manual Installing the Memory Module