HP ESL9000 manual Completing the Procedure, Turning the Library On

Installing the Memory Module

Completing the Procedure

Completing the memory module installation procedure consists of the following steps:

■Turning the Library On

■Initializing Non-Volatile RAM

■Setting the Library for HP Mode

■Changing the Library Settings

■Setting the Number of Tape Drives

■Calibrating the Library

Turning the Library On

To turn on the library:

1.Turn on the main circuit breaker switch (CB1) on the AC distribution assembly. If two AC distribution assemblies are installed, turn on CB1 on each assembly.

Note: The AC power distribution assembly is located in the lower left part of the cabinet base, behind the rear access panel.

2.Close the library doors.

3.Turn on the power switch, located below the GUI.

The GUI lights and displays Power-Up. After a few seconds, it displays either Initializing for On-lineor System Off-line, depending upon the setting of the Power-On State option.

4.If the GUI displays Initializing for On-line, press the Stop button, the Standby button, and then the Stop button again to place the library off-line.

Caution: Do NOT let the robot initialize. Press the Stop and Off-linebuttons immediately after power-on.

When the library finishes going off-line, the GUI displays System Off-line.

HP StorageWorks ESL9000 Series Tape Library Memory Module Upgrade Guide 15