HP Folio 1040 G1 Description Spare part number, Display bezels, Webcam module with microphone

Display assembly components (panel, bezel, webcam, microphone)

All display assemblies include WLAN antenna transceivers and cables. WWAN models also include 2 WWAN antenna transceivers and cables.

Full hinge-up displays are not spared.

This section describes removing components that do not require that you entirely remove the display assembly from the computer. You can remove the display bezel, webcam/microphone module, and display panel with the display assembly still attached to the computer.

To remove the remaining display components, including the display brackets, antennas, and enclosure, you must remove the entire display assembly from the computer. See Display assembly on page 37 for more information about removing the remaining components.

Description	Spare part number
Display panels (35.6-cm [14.0-in], anti-glare, LED)
SVA HD+	739581-001
UVWA	739582-001
Display bezels
For use with models with a webcam	739568-001
For use with models without a webcam	748015-001
Webcam module with microphone	739570-001
Microphone module	739571-001

Before removing the display panel, follow these steps:

1.Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on, and then shut it down through the operating system.

2.Disconnect all external devices connected to the computer.

3.Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and then unplugging the AC adapter from the computer.

4.Remove the battery (see Battery on page 41).

Remove the display assembly components:

1.Position the computer upright, with the front toward you.

2.Open the computer as far as possible.

3.If it is necessary to replace the display bezel:

a.Close the computer, position it so you can access the bottom of the display, and then open the computer slightly.

Component replacement procedures 31