HP FP9419 manual Select Image Control

Troubleshooting

Problem	Possible Cause	Solution
Image is not	Position may need	Press the Menu button to
centered.	adjustment.	access the OSD Menu.
		Select Image Control/
		Horizontal Position or
		Vertical Position to adjust
		the horizontal or vertical
		position of the image.
“No Connection,	Monitor video cable is	Connect the 15-pin monitor
Check Signal Cable”	disconnected.	video cable to the VGA
is displayed on		connector on the computer,
screen.		or connect the DVI-D signal
		cable to the DVI connector
		on the computer. Be sure
		that the computer power is
		off while connecting the
		video cable.

“Out of Range. Set Monitor to 1280 x 1024 @ 60Hz” is displayed on screen.

Video resolution and/or refresh rate are set higher than what your monitor supports.

Restart your computer and enter Safe Mode. Change your settings to a supported setting (see the table in “Preset Video Modes” in Appendix B). Restart your computer so that the new settings take effect.

A–2 User’s Guide