HP gnu source-level debugger 5992-4701 21.5 GDB/MI breakpoint table commands, break-after Command

Note the line breaks shown in the examples are here only for readability. They do not appear in the real output. Also note that the commands with a non-available example (N.A.) are not yet implemented.

Motivation

The motivation for this collection of commands.

Introduction

A brief introduction to this collection of commands as a whole.

Commands

For each command in the block, the following is described:

Synopsis

-command args...

GDB command

The corresponding GDB CLI command.

Result

Out-of-band

Notes

Example

21.5 GDB/MI breakpoint table commands

This section documents GDB/MI commands for manipulating breakpoints.

The -break-after Command

Synopsis

-break-after number count

The breakpoint number number is not in effect until it has been hit count times. To see how this is reflected in the output of the '-break-list' command, see the description of the '-break-list' command below.

GDB command

The corresponding GDB command is 'ignore'.

312 The GDB/MI Interface