HP H5400 manual Enter the profile information, Tap Next

Using the Wireless LAN

4. Enter the profile information.

Field Name	Information
Profile Name	Enter a name for your profile.
SSID	This is the service set identifier (SSID) and the
	default is “blank” when connecting to an
	infrastructure network. This allows you to
	connect to any available access point.
	You and the wireless site you want to connect to
	must use the same SSID. This identification
	number uses a maximum of 32 characters and
	is case sensitive.
Power Management	The default selection is “No.” Selecting “Yes”
	will provide lower performance and use less
	power.
Network	You have two choices: infrastructure or ad
	hoc.The default selection is “Infrastructure.”
	Use infrastructure to connect to a wired network
	via a wireless access point.
	Use ad hoc for peer-to-peer communications.
Channel	The default is “Auto.”
	You do not need to specify a channel if you are
	using an infrastructure network. It will use the
	same channel as the access point.
	Otherwise, set the frequency that corresponds
	to your country’s regulatory commission’s range
	and the 802.11b standard.
Transmission Rate	The default is “Auto.”
	This is the wireless data transmission
	speed. You can select speeds of 1, 2, 5.5,
	or 11 Mbps.

5.Tap Next.

6.Tap “Use server-assigned IP address” and use the DHCP server address or select “Use specific IP address.”

3–6 Reference Guide