when there is an intervening empty slot. The -S 0 option effectively forces a sequential set of values to be generated for %xi and the IP since intervening slots without cartridges won't effect their values.

-p hostname_prefix

If this option is specified, the hostname specified in -hmust be a fixed string and have a numeric suffix. For example, 'n01', 'node_01', 'zeus001'. The suffix is incrementally increased to create subsequent hostnames. The hostname_prefix is the leading characters intended to be common to all compute node names. For example, if the first hostname is 'zeus001' the prefix is 'zeus'.

OPTIONS (general)-i first_ip_addr

Use first_ip_addr as the first node IP address. The IP address is incrementally increased to create subsequent addresses. Addresses should be of the form w.x.y.z where 0<=w,x,y,z<=255. For HP iLO CM, this should be the IP address for the first node in the first cartridge slot. As part of the IP generation, addresses are incrementally increased to account for each slot without a cartridge as is done for %xi.

-t BMC_typeString specifying the BMC type. (e.g. ILO, ILOCM)-f BMC_ip_addr_file

Specifies a file of BMC IP addresses to be scanned. IP addresses should be white-space or line separated in the file. This option can be used separately from or in addition to the -boption.

-b BMC_ip_addr

BMC_ip_addr is a comma-separated list (no spaces) of the BMC addresses to scan. When only one BMC address is provided, the -noption can be used to generate a sequential set of addresses to scan. When the BMC type is ILOCM, multiple nodes may be scanned per BMC address.

-n num_to_discover

This option is only valid when one BMC IP address is specified in -b. num_to_discover is the number of consecutive BMC addresses to scan beginning at BMC_ip_addr. When the BMC type is ILOCM, multiple nodes may be scanned per BMC address. The default is n = 1.

-m netmask

Use netmask as the subnet mask for the generated node definitions. netmask should be of the form w.x.y.z where 0<=w,x,y,z<=255.

-a architecture

Use the specified architecture in the generated node definitions. Valid architectures are defined by CMU_VALID_ARCHITECTURE_TYPES in cmuserver.conf. Defaults to first architecture defined by CMU_VALID_ARCHITECTURE_TYPES.

-N NIC_num

(ILOCM only) Specifies which compute node NIC is connected to the admin network. All discovered compute nodes are assumed to be connected on the same NIC. By default, NIC_num is 1. NIC_num must be > 0.

-o output_file

Write node definitions to output_file rather than inserting them into the HP Insight CMU database. Nodes can subsequently be added to the database using cmu_add_node.

171