HP J9079A Defining the Members of a Trunk, Deleting the Members of a Trunk, Port, Trunk, T1-T12, IP-Info:, Member.”, 2.Click APPLY, 2. Click APPLY, to 7 ports each

Using the ProCurve Web Browser Interface

Using the ProCurve Web Browser Interface

Web Configuration

■IP-Info: The source and destination IP addresses and TCP/UDP ports in a frame are used to determine the output link in the trunk. This mode works best for switch-to-router trunk links where traffic through the switch is received from and destined for many different hosts.

Defining the Members of a Trunk

1.On the Trunks Membership page, click on the radio button in any one of these columns of the corresponding trunk.

For example, if you want ports 2, 3, 4, and 5 to become members of Trunk 2, click the radio buttons for 2, 3, 4, and 5 under the column labeled “Trunk T2.”

2.Click APPLY.

Deleting the Members of a Trunk

1. On the Trunks Membership page, click on the radio button under the

	column labeled “Not a Trunk Member” for any port you want to remove
	from a trunk. To delete a trunk, remove all port members from that trunk.
	For example, if you want to remove ports 2, 3, 4, and 5 from Trunk 2, click
	the radio buttons for 2, 3, 4, and 5 under the column labeled “Not a Trunk
	Member.”
	2. Click APPLY.
N o t e	For the 8 port switch, you can only create up to a maximum of 4 trunks of up
	to 7 ports each.

Field Attributes

•Port – The port number.

•Not a Trunk Member – If the radio button in this column is selected, the port is not a member of any trunks. This is the default state.

•Trunk T1-T12– These columns correspond to the trunks that are supported by the switch. To assign a port to a trunk, click on the radio button in any one of these columns of the corresponding trunk and then click APPLY.

2-18