![](/images/new-backgrounds/1152226/15222683x1.webp)
9.Press the OK button on the front panel.
Advance the substrate using the arrows on the front panel. Make sure that the substrate passes in front of the loading table, as shown.
Handle the substrate
10.Pull down the center of the substrate's leading edge to straighten the substrate. Do not attempt to pull more substrate out of the printer.
NOTE: If you are loading the
11.Adjust the position of the core on the
12.Tape the leading edge of the substrate to the core in the center, then at each side. Make sure that the substrate is straight.
13.Press the OK button on the front panel. The printer advances the substrate.
38 Chapter 4 Handle the substrate | ENWW |