Fingerprint reader board
Description | Spare part number |
|
|
Fingerprint reader board | |
|
|
Before removing the fingerprint reader board, follow these steps:
1.Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on, and then shut it down through the operating system.
2.Disconnect all external devices connected to the computer.
3.Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then unplugging the AC adapter from the computer.
4.Remove the battery (see Battery on page 41), and then remove the following components:
a.Service access cover (see Service access cover on page 42.)
b.Keyboard (see Keyboard on page 62.)
c.Base enclosure (see Base enclosure on page 66.)
d.Top cover (see Top cover on page 71.)
Remove the fingerprint board:
1.Remove the Phillips M2.0x3.0 screw (1) from fingerprint reader frame, and then remove the frame (2).
2.Remove the tape (3) from fingerprint reader cable, and then remove the board and cable (4) from the top cover.
Reverse this procedure to install the fingerprint reader board.
Component replacement procedures 75
