HP LTO 4 FC, LTO 4 SCSI, LTO 4 SAS manual

	Flag	Type	Set	Recommended Host Message	Cause
32	Interface	W		The tape drive has a problem with	The drive has identified an
				the application client interface:	interface fault.
				1. Check the cables and cable
				connections.
				2. Restart the operation.
33	Eject media	C		The operation has failed:	Error recovery action.
				1. Eject the tape or magazine.
				2. Insert the tape or magazine
				again.
				3. Restart the operation.
34	Download fail	W		The firmware download has failed	Firmware download failed.
				because you have tried to use the
				incorrect firmware for this tape drive.
				Obtain the correct firmware and try
				again.
35	Drive humidity	W		Environmental conditions inside the	The drive’s humidity limits
				tape drive are outside the specified	have been exceeded.
				humidity range.
36	Drive	W		Environmental conditions inside the	The drive is experiencing a
	temperature			tape drive are outside the specified	cooling problem.
				temperature range.
37	Drive voltage	W		The voltage supply to the tape drive	Drive voltage limits have
				is outside the specified range.	been exceeded.
38	Predictive failure	C		A hardware failure of the drive is	Failure of the drive’s
				predicted. Call the tape drive	hardware is predicted.
				supplier ‘s helpline.
39	Diagnostics	W		The tape drive may have a hardware	The drive may have a
	required			fault. Run extended diagnostics to	hardware fault that may be
				verify and diagnose the problem.	identified by extended
				Check the tape drive user’s manual	diagnostics (using a SEND
					DIAGNOSTIC command).
				for instructions on running extended
				diagnostic tests.
Flags for Additional Tape Drive Errors
				Flags 40–49 are not currently used.
50	Lost statistics	W		Media statistics have been lost at	The drive or library has been
				some time in the past.	powered on with a tape
					loaded.

84 Exception handling

HP restricted