HP MR4000N manual Setup, Rear Panel Connectors

Setup

Rear Panel Connectors

RF Input (labeled AIR 75 ohm)

Connect an outdoor or indoor antenna.

Monitor Out

Connect composite cables to your TV or monitor. Insert the yellow video cable into the Video connector and the white and red cables into the Audio L and R connectors, respectively.

Component Out

Connect component cables to your TV or monitor. Insert the green, blue, and red video cables into the Y, Pb, and Pr connectors and the white and red cables into the Audio L and R connectors, respectively.

Digital Audio Out

Connect a cable from the digital audio input of your audio receiver.

Resolution Select

Choose a resolution setting that corresponds with the TV or monitor you are using.

•1080i (interlaced scanning): Use this setting if you have an HDTV-ready 16:9 (wide screen) aspect ratio TV monitor with HDTV-ready component video inputs that can handle the 1080i video output format.

•720p (progressive scanning): Use this setting for an HDTV-ready 16:9 (wide screen) aspect ratio TV monitor with HDTV-ready component video inputs that can handle the 720p video output format.

•480p (progressing scanning): Use this setting for a digital-ready 4:3 aspect ratio TV monitor with progressive scan DTV-ready component video inputs that can handle the 480p video output format. The TV monitor may be labeled as “enhanced definition” or “progressive scan.”

•480i (interlaced scanning): Use this setting for a conventional TV with composite video.

4Setup