HP mt40 Mobile manual Adding an IP address to the policy filter blacklist

HP Velocity troubleshooting				Troubleshooting procedures
	Statistic name	Description
	Local IP	The local IP address for the protected flow.
	Local Port	The local TCP or UDP port number for the protected flow. If the port
		number is a well-known protocol, the protocol name also appears.
	Protocol	The protocol (such as TCP or UDP) used by the protected flow.
	LiveTCP	Indicates whether LiveTCP is protecting the flow. The modes are:
		•	Protecting: LiveTCP is providing latency mitigation to the flow.
		•	Inspecting: LiveTCP is in a monitoring state as network conditions have
			not been satisfied to provide protection for the flow.
		•	Off: LiveTCP is not active.
		•	N/A: LiveTCP is not applicable for the flow.
	LiveQ	Indicates whether HP Velocity is protecting the flow or monitoring the flow
		for packet loss.
	TLR	The TLR applied to the protected flow as a percentage that HP Velocity will
		attempt to achieve.
	Encoding	The encoding level applied to the protected flow.

Adding an IP address to the policy filter blacklist

To add an IP address to the policy filter blacklist:

1.On the HP Velocity server system, right-click the HP Velocity system tray icon.

2.Select Management.

3.Click Configuration.

4.Select Policy Filters in the navigation tree.

5.In the Blacklist field of the IP Address pane, enter the IP address and netmask, using the format xxx.xxx.xxx.xxx/xx, and separating each entry with a space.

6.Click Apply.

For more information, see the “Policy Filters (Port & IP)” section of the HP Velocity Server Side Deployment Guide.

HP Velocity FAQ and Troubleshooting Guide 29