•Missing HP Photosmart Software
Firmware revision mismatch
Solution: Contact HP support for service.
Go to: www.hp.com/support.
If prompted, choose your country/region, and then click Contact HP for information on calling for technical support.
Cause: The revision number of the product firmware did not match the revision number of the software.
Memory is full
Solution: Try making fewer copies at a time.
Cause: The document you were copying exceeded the memory of the product.
Photo tray problem
Try the following solutions to resolve the issue. Solutions are listed in order, with the most likely solution first. If the first solution does not solve the problem, continue trying the remaining solutions until the issue is resolved.
•Solution 1: Load more paper in the photo tray
•Solution 2: Make sure paper is loaded correctly in the photo tray
•Solution 3: Remove excess paper from the photo tray
•Solution 4: Make sure the sheets of paper are not stuck together
Solve a problem
Solution 1: Load more paper in the photo tray
Solution: If the photo tray is empty or there are only a few sheets remaining, load more paper in the photo tray. If there is paper in the photo tray, remove the paper, tap the stack of paper against a flat surface, and reload the paper into the photo tray. Follow the prompts on the display or the computer screen to continue your print job.
Do not overload the photo tray; make sure the stack of photo paper fits within the photo tray and is no higher than the top of the
Cause: There was not enough paper in the photo tray. If this did not solve the issue, try the next solution.
Errors 97