HP R7000 Verifying the REPO port connection

Main menu	Submenu	Display information or menu function
—	Battery status	Battery Charging/Floating/Resting, Charge
		Level, ERM Number, and Runtime
Event Log	—	Displays events and alarms
Measurements	Output	Output watts and VA
—	Output	Output amps and power factor
—	Output	Output voltage and frequency
—	Input	Input voltage and frequency
—	Battery	Battery voltage and percent charge
Control	Go to Bypass mode	Transfers the UPS system to internal Bypass
		mode
		When this command is active, the option
		changes to Go to Normal mode.
—	Battery Test	Schedules a battery test
—	Reset error state	Reset alarms
—	Load segments	Turns load segments on or off
—	Restore factory settings	Resets the UPS back to factory settings
Settings	Change language	Changes language settings. The default is
		English.
—	User Password	Enables or disables password. Default: Disable.
		If Enable is selected, the password is USER. The
		password cannot be changed.
—	Set date and time	Sets date and time
—	Control commands from serial	Enables or disables serial port control
	port	commands. Default: Enabled
—	Output voltage	Sets output voltage
—	Auto start delay	Selects load segment and delay time in seconds
—	Automatic on battery shutdown	Selects load segment and delay time in seconds
—	On battery notice delay	Sets delay time in seconds
—	Site wiring fault alarm	Enables or disables site wiring fault alarm. The
		default is Disabled
—	Battery low alarm	Sets battery low alarm. Default: 3 minutes.
—	Automatic battery test	Enables or disables battery test. Default:
		Disabled
—	LCD contrast	Change LCD contrast. Default: +0
Identification	—	UPS Type / Part Number / Serial Number /
		NMC Firmware / Comm Firmware / UPS
		Firmware

Verifying the REPO port connection

NOTE: While testing, operate connected equipment in a safe test mode so the effects do not disrupt critical operations.

After connecting the REPO port (on page 21):

UPS operations 33