HP Comprehensive Guide to Replacing Hard Drives in RP3 Systems

Replacing the Hard Drive

NOTE: The HP RP3 computer supports 2.5-inch Serial ATA (SATA) internal hard drives.

Before you remove the old hard drive, be sure to back up the data from the old hard drive so that you can transfer the data to the new hard drive.

The 2.5-inch hard drive is enclosed in a carrier on the interior of the front panel. To replace the drive:

1.Remove/disengage any security devices that prohibit opening the computer.

2.Remove all removable media, such as USB flash drives, from the computer.

3.Turn off the computer properly through the operating system, then turn off any external devices.

4.Disconnect the power cord from the power outlet and disconnect any external devices.

CAUTION: Regardless of the power-on state, voltage is always present on the system board as long as the system is plugged into an active AC outlet. You must disconnect the power cord to avoid damage to the internal components of the computer.

5.Remove the computer access panel.

6.Disconnect the cables from the rear of the hard drive. Figure 2-27Disconnecting the Hard Drive Cables

Replacing the Hard Drive 25