INDICATION | DESCRIPTION | LED | BEEPER |
Label Programming Mode | In cases where multiple | N/A |
Acceptance of Partial Label | labels must be scanned to |
|
| program one feature, this |
|
| indication acknowledges |
|
| each portion as it is |
|
| successfully scanned. |
|
Scanner sounds one short beep at highest frequency and current volume.
Label Programming Mode | Configuration option(s) have | N/A | Scanner sounds one high |
Acceptance of Programming | been successfully |
| frequency beep and 4 low |
| programmed via labels and |
| frequency beeps followed by |
| the scanner has exited |
| reset beeps. |
| Programming Mode. |
|
|
|
|
|
|
Label Programming Mode | Cancel label has been | N/A | Scanner sounds two times at |
Cancel Item Entry | scanned. |
| low frequency and current |
|
|
| volume. |
|
|
|
|
Error Codes
Upon startup, if the scanner sounds a long tone, this means the scanner has not passed its automatic Selftest and has entered FRU (Field Replaceable Unit) isolation mode. If the scanner is reset, the sequence will be repeated. Press and release the trigger to hear the FRU indication code.
The following table describes the LED flashes/beep codes associated with an error found.
Number of LED Flashes/Beeps | Error | Corrective Action |
|
|
|
1 | Configuration | Contact Help desk for assistance |
|
|
|
2 | Interface PCB | Contact Help desk for assistance |
|
|
|
6 | Digital PCB | Contact Help desk for assistance |
|
|
|
11 | Imager | Contact Help desk for assistance |
|
|
|
20 Appendix B Technical Specifications