HP RX4610 manual Planning your HP-UX 11i Version 1.5 Cold Install

Installing HP-UX 11i Version 1.5

Planning your HP-UX 11i Version 1.5 Cold Install

media to the hard disk. The system will automatically reboot during the installation process.

Step 22. After the system has rebooted, the Welcome to HP-UX screen is displayed. At this point, you will need to answer a few questions before you can use the system. The first is whether or not you plan to use the system on a network. If you have completed the pre-install data collection tables in Appendix C, you have all of the information you need to complete the networking section of the install, so answer Y for yes.

Step 23. On the following screens, enter the basic network configuration information that you collected in Appendix C. Depending on how you set up your parameters, the system either will have configured them automatically or will call the set_parms command to allow you to set the root password, date and time, time zone, IP address, and additional network parameters.

Step 24. Confirm your choices. Congratulations! You are now finished with the install procedure and will be given the opportunity to log in to the system as root.

Step 25. Log in to the system.

Step 26. After the cold install, store the HP-UX OS DVDs in a safe place. You may

need them to install drivers or other software later.

Chapter 2 35